164
“OPTI LINE”
6-102
6-90
1
4
5
6
Start a new Set of Wheels
After entry of WHEEL No. 5 in a Set, you can start
a new Set, without exiting the Set of Wheels mode.
Proceed as follows:
• Perform the procedure as described for wheel
No. 1.
The machine deletes the data relative to the previ-
ous wheels and shows the current wheel as the first
wheel in a new Set.
After entry of WHEEL No. 4 in a Set you can start
a new Set, without exiting the Set of Wheels mode.
Proceed as follows:
• Mount the wheel on the balancer shaft.
• Perform the run.
• Complete any normal correction and
balancing operations required.
• Remove the wheel from the balancer.
• Access the “Set of Wheels” screen (1, Fig.
6-90).
Wheel number 5 is shown on the screen page (Fig.
6-102).
• Select key 4.
The machine deletes the data relative to the previ-
ous wheels and shows the last wheel as wheel
number 1, starting a new Set of Wheels.
Terminate and exit procedure
To exit the Set of Wheels procedure and return to
the OPTIMA ENTRY screen page.
• Press key 5 (Fig. 6-102).
All data relative to the Set of Wheels is deleted.
..
_
..........
To Next Page
Loading...
