66
“MANUAL MODE”
6.1 MANUAL Mode - Settings
To establish the imbalance value the machine must
have been given the following basic information:
– Vehicle type (depending on rim type)
– balancing mode (weight fi
tting position on rim)
– Rim width and diameter (nominal or effective)
– Distance between machine and left correction
plane
This data can be entered one at a time by recalling the
various options in the respective menus. This allows
the machine to calculate imbalances on the basis of
NOMINAL (theoretical) data.
For normal balancing procedures it is always better to
enter data using the automatic data reading system.
..
_
..........
To Next Page
Loading...
