170
7-07
Operation
7.0.1.2 How to fi t adhesive weights based on
given dimensions
If the correction positions are not accessible with the
gauge arm and the wheel dimensions have been
entered using the function keys:
— Fit adhesive weights in the given positions according
to the balancing mode. Make sure to observe the
given positioning dimensions (Fig. 7-07).
Dimensional tolerances result in slight deviations of
the measured values so that the weight may need to
be repositioned after the check run. In this case an OK
indication is not displayed after the check run.
..
_
..........
To Next Page
Loading...
