John Bean B 2000P - Page 214

214
9-2
9-1
Trouble shooting
9.1 System messages
The wheel balancer can show messages to the
operator. These may be error related (E-codes) (e.g. E
2 - Figure 9-1), warnings (H-codes) (e.g. H33 - Figure
9-2) or Hardware problems (X-Codes). The codes will
be described in the following chapters.
Whenever a code appears:
• make a note of it;
• look up the code in the list.
• perform the steps described.
Important:
If the code is not listed here, call service team.
Errors in operation
- Error code E
Warnings - Error code H
Fatal error code - 300 or C10
9.1.1 E-Codes
E1
Rim dim
ensions were entered incorrectly, or
incompletely.
— When the error code is read out, enter data once
again.
E2
Wheel guard is not closed.
E5
Range of electrical compensation exceeded
(wheel adaptor has unacceptable unbalance).
— Press STOP or ESC–key
.
— Check wheel adaptor, repeat compensation run.
E6
The calibration weight was not fi tted for readjustment.
— Press STOP or ESC–key.
— Repeat readjustment.
E7
With this wheel type it is not possible to choose a
balancing mode.
— If necessary, choose another wheel type.
..
_
..........