70
STATIC
HWM
“MANUAL MODE”
6-5
6-4
6.1.2 Weights positioning Modes
NORMAL (ALU 0)
Used for steel rims.
ALU mode
U
sed fo
r light alloy rims or where one or more stick-
on weights are to be used.
The stick-on weight(s) must be applied by hand.
Hidden Weight Mode (HWM)
Used for light alloy rims or for wheels that are
diffi cult to balance.
There are two HWM ALU modes (ALU2P & ALU3P).
These differ from other ALU modes in that the
weights on the left and right balancing planes are
both applied in the inner part of the rim (Figure 6-4).
The stick-on weight(s) must be applied with the
gauge arm. This guarantees more accurate weight
positioning compared to applying the stick-on
weight(s) by hand.
Note: If the stick-on weight must be hidden
behind two spokes, select the Split Weight
Mode before applying the weight in the
right plane (F 7.
0.4
).
STATIC
(Figure 6-5)
Retrieve the function with key (Fig. 6-5).
Used for small wheels that are not balanced
dynamically, e.g.: small moped wheels.
No “left” or “right” weight is calculated.
— Mount the wheel according to paragraph 5.4 and
select the corrected reading positions of the gauge
head (F 5.5.1).
..
_
..........
— Mount the wheel according to paragraph 5.4 and
select the corrected reading positions of the gauge
head.
To Next Page
Loading...
