John Bean VPI System - Table of Contents

Page 3
John Bean VPI System I Operators Manual
TABLE OF CONTENTS
General Safety Instructions Pages 1 & 2
1.0 Introduction Page 4
1.1 Safety Notice Page 4
1.2 Balancer Application Page 4
1.3 Specifications Page 5
1.4 Balancer Features Page 5
1.5 Standard Accessories Page 6
1.6 Optional Accessories Page 6
1.7 Dimensions Of The Machine Page 7
1.8 Installation Area Page 7
1.9 Installation Instructions Page 7
2.0 Shaft Adapter Installation Page 7
2.1 Wheel Guard Installation Page 8
2.2 Electrical Installation Page 8
2.3 Perform a User Calibration Page 8
3.0 Terminology Page 9
4.0 Balancer Operation Page 10
4.1 Inspection Check list Page 10
4.2 Wheel Mounting Page 10
4.2.1 Mounting of Standard Wheels Page 10
4.2.2 Mounting of Light Truck Wheels Page 11
4.3 Mode Selection Page 11
4.3.1 Weight Placement Modes Page 11
4.4 Selecting Operator Preferences Page 12
4.4.1 Fine Balance Mode Page 12
4.4.2 Ounce /Grams Conversion Page 12
4.4.3 Inch/Millimeter Conversion Page 12
4.4.4 Selection of Operator A/B Page 12
4.5 Entering Rim Parameters Page 13
4.5.1 Entering Distance (offset) with SAPE Page 13
4.5.2 Entering Rim Diameter Page 13
4.5.3 Entering Rim Width Page 13
4.5.3.1 Manual Distance Entry Page 13
4.6 Correcting the Imbalance Page 14
4.7 Verifying Results Page 14
4.8 Vibration Problems Page 14
5.0 Matching Program Page 15
6.0 Optimization Program Page 17
7.0 Alu-S Program Page 18
8.0 Spoke Mode Page 19
9.0 Split Weight Mode Page 20
10.0 User Shaft Calibration Page 21
11.0 Distance Gauge Calibration Page 22
11.0 Explanation of "F" Codes Page 23
12.0 Maintenance Page 23
13.0 Trouble Shooting Page 23