FIRECLASS Fire detection system Install the Batteries
Installation Guide Doc. version 2.0 13
6 Install the Batteries
NOTICE
DANGER
Ensure that the battery complies with the
following:
It is of the valve regulated lead acid (VRLA)
type.
It has an enclosure with flammability class
UL94V-1 or better.
It complies with all applicable standards indi-
cated in paragraph M.2.1 of standard EN
62368-1:2014 Requirements (safety of bat-
teries and their elements); in this case the
standards: IEC 60896-21: 2004 and IEC
60896-22: 2004.
It is a replaced by a skilled person.
The standby batteries can deliver high
current, producing a danger of injury and
equipment damage while working on the
panel.
Take care not to accidentally short the
battery terminals, especially when fitting
the retaining bracket. The batteries are
supplied charged.
Battery variations
Your batteries may differ from the ones
shown in the illustrations below (which are
POWER SONIC 38 Ah batteries).
Fig. 11: Battery in-line fuse kit
To Next Page
Loading...
Need help?
General
