Need help?Do you have a question about the Johnson Controls Frick XL and is the answer not in the manual?
General| Brand | Johnson Controls |
|---|---|
| Model | Frick XL |
| Category | Computer Hardware |
| Language | English |
Imminent hazard leading to death or serious injury.
Potential hazard leading to death or serious injury.
Potential hazard leading to equipment damage or minor injury.
Essential operating procedure, practice, or information.
Recording unit model, serial, and motor data for reference.
Crucial safety practices for installation and operation.
Tools required for proper installation of Evaporative Condensers.
Unit anchoring and structural support guidelines.
XLC unit foundation dimensions and beam requirements.
Rigging and assembly steps for XLC fan/coil sections.
XLP unit foundation dimensions and beam requirements.
Rigging and joining XLP fan/pan and coil sections.
Steps for installing vibration isolator feet.
Steps for installing vibration isolator rails.
Pre-startup checks of unit components and systems.
Passivation procedure for galvanized surfaces.
Operating guidelines for cold environments and freeze protection.
Water quality, chemical treatment, and pH guidelines.
Recommended maintenance tasks and frequencies.
Checks and lubrication for fan motors, bearings, drives, and sheaves.
Maintenance for eliminators and water distribution system.
Procedures for sheave alignment, belt replacement, and tensioning.
Procedures for unit startup after shutdown.
Steps for properly shutting down the unit.
To Next Page