8
Hardware Installation—Installing the
IFC-1010/2020
•
Telephone lines needed to transmit alarm signals from a premise to a
central monitoring station may be out of service or temporarily
disabled.
The most common cause of fire alarm malfunctions, however, is
inadequate maintenance. All devices and system wiring should be tested
and maintained by professional fire alarm installers following written
procedures supplied with each device. System inspection and testing
should be scheduled monthly or as required by national and/or local fire
codes. Adequate written records of all inspections should be kept.
!
WARNING: This equipment generates, uses, and can radiate radio
frequency energy if not installed and used in
accordance with the instruction manual, may cause
interference to radio communications. It has been
tested and found to comply with the limits for Class A
computing device pursuant to Subpart B of Part limits
for Class A computing device pursuant to Subpart B
of Part 15 of FCC Rules, which is designed to provide
reasonable protection against such interference when
operated in a commercial environment. Operation of
this equipment in a residential area is likely to cause
interference, in which case the user will be required to
correct the interference at his own expense.
Le Present apparell numerique n’emet pas de bruits radioelectriques
depassant les limites applicables aux appareils numeriques de la classe A
prescrites dans le Reglement sur le brouillage radioelectrique edicte par le
ministere des Communications du Canada.
FCC Warning
Canadian
Requirements
To Next Page
Loading...
Need help?
General
