Johnson Controls PEAK OEM 18 User Manual

PEAK® OEM 18 240 Volt SMART Equipment Controller
Installation Instructions
1
(barcode for factory use only)
Application
PEAK® OEM 18 is part of the SMART Equipment Controller family. The PEAK OEM 18 controllers run pre-
engineered applications and provide the inputs and outputs required to monitor and control a wide variety of
HVAC/R equipment.
PEAK OEM 18 controllers operate on an RS-485 BACnet® Master-Slave/Token-Passing (MS/TP) Bus as BACnet
Advanced Application Controllers (B-AACs) and integrate into Johnson Controls® and third-party BACnet systems.
PEAK OEM 18 controllers include an integral real-time clock, which enables the controllers to monitor and control
schedules, calendars, trends, and operate for
extended periods of time as stand-alone controllers when offline from
the system network. The PK-OEM18x1-0 models operate on 120/240 VAC Universal Power Supply.
Communication Protocols and Tools
CCT Release 10.3 with OEM package can be used to switch the Field Bus communications protocol in PEAK OEM
Controllers to act
as either standard BACnet® Master-Slave/Token-Passing (MS/TP) devices, Modbus® RTU
devices, or as N2 protocol devices. BACnet MS/TP is the default for all new controllers. Switchable
communications protocols provide a cost-effective upgrade and modernization path for customers with existing
N2 controllers. The OEM package is required to make changes to the application.
The PEAK OEM 18 controllers can be used as HVAC/R application controllers. The BACnet standard PEAK
OEM 18 controllers include:
• I/O quantities and characteristics of the PEAK OEM 18 family controllers
• real-time clock with local display, built-in BACnet schedule objects and calendars
• Mobile Access Portal (MAP) compatibility for configuration through smart mobile devi
ces and remote
connectivit
y.
• multi-protocol support for BMS integration, BACnet MS/TP, N2 and Modbus RTU (through on-board display)
• dedicated SA bus for Johnson Controls smart end-devices
• dedicated Modbus port for third-party end-device integration, Modbus Master
• various product options with or without display and support of Power input of 120/240 VAC
IMPORTANT: Use this PEAK OEM 18 240 Volt Controller only as an operating control. Where failure or
malfunction of the PEAK OEM controller could lead to personal injury or property damage to the controlled
equipment or other property, additional precautions must be designed into the control system. Incorporate and
maintain other devices, such as supervisory or alarm systems or safety or limit controls, intended to warn of or
protect against failure or malfunction of the PEAK OEM controller.
IMPORTANT : Utiliser ce PEAK OEM 18 240 Volt Controller uniquement en tant que dispositif de contrôle de
fonctionnement. Lorsqu'une défaillance ou un dysfonctionnement du controller risque de provoquer des
blessures ou d'endommager l'équipement contrôlé ou un autre équipement, la conception du système de
contrôle doit intégrer des dispositifs de protection supplémentaires. Veiller dans ce cas à intégrer de façon
permanente d'autres dispositifs, tels que des systèmes de supervision ou d'alarme, ou des dispositifs de
sécurité ou de limitation, ayant une fonction d'avertissement ou de protection en cas de défaillance ou de
dysfonctionnement du PEAK OEM controller.
PEAK® OEM 18 240 Volt SMART Equipment Controller
Installation Instructions
PK-OEM18x1-0
Part No. 24-10143-926, Rev. B
Issued February 2017
24- 10143- 926, Rev. B

Johnson Controls PEAK OEM 18 Specifications

General

Brand	Johnson Controls
Model	PEAK OEM 18
Category	Controller
Language	English