542933-UIM-D-0513
Johnson Controls Unitary Products 35
Restart Firmware:
Restarting the firmware will simulate a power loss to the Touch Screen Communicating Control.
This will restart the Touch Screen Communicating Control, which will validate all of the system set-
tings and resume normal operation.
Restore Defaults:
Restoring defaults on the Touch Screen Communicating Control will return the control to its original
factory settings. Upon re-boot, the control will run through auto setup screens as described earlier in
this document. Restore defaults may be used when there is a System Miconfiguration that could be
caused by a change in hard jumper settings or a change in equipment (which may include when an
installer installs a furnace in the winter and then comes back in the spring to install an AC or heat
pump).
User Interface Settings
This screen is used to customize homeowner access. There are several options to limit what the
“homeowner” sees and how the touch screen will display.
To change a setting, simply press the desired
box and a check mark will fill the selected setting
(as pictured). To understand how these settings
affect the functionality of the Touch Screen Com-
municating Control, reference the table below.
When selecting “No” on this screen the installer is restricting what can be viewed/edited by the
“Homeowner”.
Back
UI Settings
Indoor Humidity Icon and Status
11:07AM Thu 21 Jul
Indoor Fan Icon and Status
Display Items to User?
Upgrade Firmware?
Import Configuration File?
Outdoor Temperature
Allow User to:
Yes No
To Next Page
Loading...
