Operating manual - SAB 120-151 A-frame (including ATEX)
008668 en 2019.08
7/61
Introduction to operating manual
1. Introduction to operating manual
The SABROE
®
screw compressor and the unit can be configured with various types of equipment
depending on its function and requirements. Some of the equipment may be described in this
manual even though it is not featured on your particular unit.
This manual describes:
• dangers resulting from failure to comply with safety precautions when operating the
equipment and performing maintenance tasks
• how to start, operate and stop the equipment safely
• how to act when problems occur during operation
• scheduled maintenance tasks for the equipment and when/how to carry them out safely
• components with ATEX-related specifications.
This manual is primarily intended for operators and service engineers.
It is important that the operating personnel familiarise themselves with the contents of this man-
ual in order to ensure proper and efficient operation. Johnson Controls Denmark is not liable for
damage occurring during the warranty period where this is attributable to incorrect operation.
All compressor intervention within the warranty period must be performed by competent person-
nel only. If not, the warranty no longer applies.
This manual does not describe:
• Control systems. A specific operating manual is delivered with the compressor.
• Safety when handling refrigerants and oils.
• Installation.
• Service and repair including spare part lists.
For further information, see www.sabroe.com.
This manual covers the following types of units:
• SAB 120 S
• SAB 120 M
• SAB 120 L
• SAB 120 E
• SAB 151 S
• SAB 151 M
• SAB 151 L
• SAB 151 E
American standards are used in all P&I diagrams in this manual.
To Next Page
Loading...
Need help?
General
