Name: Johnson JPE-5100
Brand: Johnson
Rating: 4 (1 reviews)

To Next Page

To Previous Page

BEARING REPLACEMENT PROCEDURE (JPS)

Tools required:

u Philips screwdriver

u Hex key (4mm)

u Bearing puller

u C-Clip pliers

u Wooden hammer

Procedure:

6. Remove the C-

clip with the C-Clip

Pliers and then

remove the Idler

Assembly by using

the Bearing Puller.

u If the Ball

Bearing failed,

replace it.

7. With the wooden

hammer tap the idler

pulley assembly back

to the pulley-axle

assembly.

8. Install all C-clips and ball bearings.

9. Install the side covers and tighten the screws.

3-17 Revision: 1.0 Date: 2001/06/01

Questions and Answers:

Need help?

Do you have a question about the Johnson JPE-5100 and is the answer not in the manual?

Johnson JPE-5100 Specifications

General