JoinTech JT709A - Page 7

7 / 41
enter deep sleep mode, and the user can
configure the remaining power percentage
for entering deep sleep;
Tracking mode: the device works
continuously and does not enter sleep ;
Standby mode: sleep by default; When the
wake-up condition is detected, the preset
data upload time interval works, and when
there is no other wake-up event, it sleeps.
Device wake-up source
Premise: the device is dormant
RTC timing wake-up
(cannot be configured to close)
Wake up at a preset time interval and
upload a piece of data, then sleep;
Vibration
(can be configured to close)
After detecting the vibration or motion, wake
up for 10 minutes, during which there is no
other wake-up source, then sleep;
Back cap opened (cannot be
configured to close)
After detecting that the Back cap is opened,
wake up for 10 minutes, during which there
is no other wake-up source, then sleep;
Lock rope inserted and unplugging
(cannot be configured to close)
When the lock rope is inserted and
unplugged, wake up for 10 minutes, during
which there is no other wake-up source,
then sleep;
External power charging
(cannot be configured to close)
Detect external charging, wake up and work
for 10 minutes, during which there is no
other wake-up source, then sleep;
Swipe RFID card
(cannot be configured to close)
Detect swiping RFID card, wake up and
work for 10 minutes, during which there is
no other wake-up source, then sleep;
Short message command/Calling
(can be configured to close)
(Default VIP number, non-VIP number
can be configured)
Detect the short message or dialing sent by
the VIP mobile phone number, then wake up
and work for 10 minutes, during which there
is no other wake-up source, then sleep;
Bluetooth commands
Receive a command from Bluetooth
channel,wake up this device and work for 10
minutes, during which there is no other
wake-up source, then sleep;