20 - 40
cube
6.5 ELECTRIC POWER SUPPLY
The JONIX cube device is ready for connection to the civil power supply network,
230V/~1/50Hz. The device is equipped with a cable with a Schuko plug.
Do not use the device if the plug and/or power cord are damaged.
Connect the plug only to a socket with the same technical characteristics.
Periodically check the condition of the power cord.
ATTENTION!
It is recommended to check that the energy delivered is stable. Otherwise a voltage
stabilizer must be installed upstream.
Before making any connections, ALWAYS make sure the mains voltage complies
with what is shown on the plate.
ATTENTION! BEFORE STARTING ANY OPERATION, MAKE SURE THAT THE GENERAL
POWER SUPPLY LINE IS DISCONNECTED AND THAT THE DEVICE CANNOT BE
ACCIDENTALLY POWERED!
6.4 ELECTRICAL CONNECTIONS
• Connect the device to an effective earthing outlet.
• The electrical connections must be carried out following the instructions provided in this
manual.
• Make sure that voltage and frequency of the electric line correspond to those provided on
the name plate.
ATTENTION!
Using a power supply that does not meet the requirements of the device may result
in damage to the device or some of its parts.
To Next Page
Loading...