25 - 40
cube
OFF
10
The JONIX cube needs a reduced maintenance which consists of periodic and regular cleaning
or replacement of the non-thermal plasma generator (ionizing tube), cleaning or replacement of
the filter and checking the correct operation of the fan.
The JONIX cube signals the need for maintenance of the non-thermal plasma generator
(ionizing tube) by turning on the "maintenance led" (yellow led):
- yellow led always on -> cleaning the ionizing tube (see paragraph 7.2.1 "Cleaning ionizing
tubes").
- yellow led flashing fast -> replacement the ionizing tube (see paragraph 7.2.4 " Replacement
ionizing tubes").
7.2 ROUTINE MAINTENANCE
The JONIX cube signals the need for cleaning of the ionising tubes, through the indicator light
shown on the display (yellow led), every 840 hours of operation.
However, when operating in highly contaminated environments, the electronics of the device
could intervene even if this time has not yet elapsed.
7.2.1 Cleaning ionizing tubes
Clean the ionising tubes as soon as the relevant LED stays on permanently.
Fixed led: cleaning required
Fig. 10: Switch the ioniser off by
switching the On/Off button to O.
Put the device on a flat surface. Remove
the plug connected to the mains.
For all maintenance operations it is good practice to use work gloves to protect
your hands.
To Next Page
Loading...