24 - 40
cube
6.8 FIRST START CHECKS
At first start-up, the device should be subjected to at least the following checks:
- check the integrity and stability of the JONIX cube as a whole;
- check that the top cover is properly attached;
- check that the mains voltage is correct in relation to what is indicated on the nameplate of the
device;
- check that on the display is off the yellow led for the ordinary maintenance request (see
paragraph 7.2 “ordinary maintenance”);
- check that the air flow is regular;
- check that you can hear the slight sizzle of the ionizing tube.
Repeat the checks carried out at the first start-up even after each extended
shutdown period and after maintenance.
7.1 WARNINGS
7 - MAINTENANCE
BEFORE CARRYING OUT ANY MAINTENANCE OPERATION MAKE SURE THAT THE
DEVICE IS NOT AND CANNOT ACCIDENTALLY BE POWERED ELECTRICALLY.
YOU MUST THEREFORE UNPLUG THE DEVICE BEFORE CARRYING OUT ANY
MAINTENANCE.
• It is the duty of the user to perform all the maintenance operations on the device listed below.
• In the event of a malfunction not indicated in this manual, disconnect the device from the
power supply and consult your dealer and / or JONIX S.p.A..
• Only specialised personnel authorized by JONIX S.p.A., can perform maintenance operations
other than those specified in this manual.
For all maintenance operations it is good practice to use work gloves to protect
your hands.
The frequency of the operations to be performed to ensure proper maintenance of the device
JONIX cube depends mainly on the quality of the treated air. Air can be especially harmful for
device when it contains polluting or aggressive substances such as:
- Industrial flue gas
- Sale
- Chemical smoke
- Heavy powders
By coming into contact with the inside or outer surfaces of the device by means of
the air flow or by direct exposure, these substances can lead to a structural and
functional failure of the device and of its performance as time passes and without
proper, systematic maintenance.
To Next Page
Loading...