30 - 40
cube
24
25
CLICK!
CLICK!
26
ON
Fig. 25: Put the mesh filter back into the
filter cover.
Reassemble the filter cover with the snap
fastening. Press it on the grid incorporated
in the closing plate until you feel the snap of
the coupling between the parts.
Fig. 24: Use a damp microfibre cloth to
wipe the plastic filter cover and the grid
incorporated in the closing plate.
Fig. 26: Reconnect the plug. Switch the
ionising device on by switching the On/Off
button to I.
The presence of high voltage
inside the device is indicated
by the relevant light, located
on the front panel, when the
device is switched on.
To Next Page
Loading...