59
5
504 91 06-05
Centrifugal clutch
Place the clutch hub in position.
Brace the clutch in a vice and stretch out
the spring with a screwdriver so that the
third clutch shoe can be fitted.
Dismantling mod. 2054/2055
Dismantle the lockring and lift off the
clutch drum.
Dismantle the clutch from the crankshaft.
Take apart the clutch and inspect the
clutch drum in the same way as described
for mod. 2041/2045/2050.
Fitting mod. 2054/2055
Inspect the clutch drum splines and the
drive wheel for wear.
Replace parts if necessary.
Place the clutch hub in position and brace
the clutch in a vice.
Use a screwdriver to stretch out the spring
so that the third clutch shoe can be pres-
sed in place.
If necessary use a pair of flat pliers to get
the spring in place.
Lubricate the clutch drum’s needle bearing
with grease and fit the clutch on the
crankshaft.
Dismantling mod. 2054/2055
Dismantle the lockring with a screwdriver.
Lift off the washer, chain gear and clutch
drum.
Replace the plug with piston stop No.
504 91 06-05 and dismantle the clutch
from the crankshaft.
Take apart the clutch and inspect the
clutch drum in the same way as described
for mod. 2041/2045/2050.
Fitting mod. 2054/2055
The clutch drum splines and drive wheel
must not be severely worn.
If this is the case replace both compo-
nents.
Screw the clutch on the crankshaft.
Lubricate the clutch drum’s needle bearing
with grease and fit the washer and lock-
ring.
To Next Page
Loading...
