Jonsered 2095 - Page 61

61
5
502 54 04-01
502 50 33-01
502 50 49-01
Centrifugal clutch
Fitting, mod. 625
Place two clutch shoes and the spring on
the clutch hub.
Fit the remaining clutch shoe.
Lubricate the clutch drum’s needle bearing
by means of a grease gun.
Dismantling mod. 630/670
Mod. 2077, 2095
Dismantle the clutch from the crankshaft.
Fitting, mod. 625
Place two clutch shoes and the spring on
the clutch hub.
NOTE!
The spring’s coupling point should lie
opposite one of the hub’s spokes.
Fit the remaining clutch shoe. Use tool
No. 502 50 49-01 and a screwdriver.
Lubricate the clutch drum’s needle bearing
by pressing in grease through the hole in
the shaft end with a suitable grease gun.
Dismantling mod. 630/670
Mod. 2077, 2095
Replace the plug with piston stop No.
502 50 33-01 and dismantle the clutch
from the crankshaft.
In order to release the clutch on mod.
2077 it is necessary to use tool No.
502 54 04-01.