Jonsered CS2186 - Felling

24 – English
ELECTRICAL SYSTEM
Replacing the generator
1. The following components must be removed before the
generator can be replaced:
A. Starter. See page 17.
B. Flywheel. See page 19.
2. Remove the bolts for the rear damper element (A) and
the travel inhibiting bolts (B). See fig. 14.
3. Remove the generator by unscrewing the three bolts.
See fig. 15.
4. Release the cable from the switch and remove the
generator.
5. Fit the new generator as shown in fig. 16 and tighten
the bolts to 4 Nm.
6. Position the cable as shown in fig. 16 and connect it to
the switch.
7. Refit the components according to item 1.
Replacing the switch
1. Remove the switch and disconnect the cables. See fig. 9.
2. Fit the cables on the new switch and press in the switch.
Fig. 14
Fig. 15
Fig. 16
A
A
B
B
B
B
B
A
B
A
B