3. Attach the front speed adjustment link in the top
hole. The clutch control hole is below the front speed
adjustment link hole.
4. Lightly lubricate the pipe couplings before you
assemble.
5. Lubricate the axles with corrosion protection before
attaching the wheels.
Note: The spacer sleeves in the wheels have
different lengths. Left: 36.3 mm + washer. Right:
45.5 mm, no washer. Do not mix up with the rear
axle spacer sleeves.
6. Fill the transmission oil tank with oil and bleed the
hydraulic system. See
To bleed the drive system on
page 30
.
7. Do a check of and adjust the parking brake cable.
See
To adjust the parking brake on AWD products
on page 17
.
8. Do a check of and adjust speed coordination
between the front wheels and rear wheels. See
To
adjust the wheel speed on page 24
.
8.5.9.3 To disassemble the rear transmission
Obey the directions in
To keep the hydraulic system
clean on page 29
.
CAUTION: Hold the connection nut with a
wrench to prevent damage to the pipes or elbow
nipples.
Note: A small quantity of oil can leak although the
transmission is drained.
1. Put support below the product.
2. Remove the rear wheels. See
To disassemble and
assemble the wheels on page 17
.
3. Drain the oil of the rear transmission. See
Transmission maintenance on page 38
.
4. Make marks on the hydraulic hoses to make it easier
to connect them correctly when you assemble them.
5. Disconnect the hydraulic hoses from the rear
transmission.
6. Attach protective plugs in the transmission and the
hoses.
659 - 001 - 11.04.2018 Repair instructions - 33
To Next Page
Loading...
