EasyManua.ls Logo

Jøtul F 520 - Initial Lighting; Ash Removal; Stacking Wood; Adding Firewood

Jøtul F 520
52 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
15
ENGLISH
Nominal heat output is achieved when the air vent is open
approx.30%. Max. heat output is achieved when the air vent
isopenapprox.50%.
Initial lighting
• Open the air vent and ignition vent by pulling the handles
allthewayout.(Useagloveorsomethingsimilartoprotect
your hand in case the handles are hot.).
Fig. 34
• Place two logs atthebottomoftheburnchamberandpile
the kindling in layers.
• Finally,placeamedium-sizedlogonthetopofthepile.
• Place 2 or 3 briquettes or kindling sticks under the top layer
ofkindlingandlightthere.NB: The maximum height of
the pile of the wood should be just below the horizontal
holes. The holes must not be covered.
• Youcanthenregulatetherateofcombustiontogivethe
heat you want by adjusting the air vent (g. 11).
• Checkthattheafterburning(secondarycombustion)starts.
Thisisbestindicatedbyyellow,ickeringamesinfrontof
theholesunderthebafe.
• Iftheairowisnormalyouwillbeabletoshutthedoorand
therewilltakecareofitself.
Adding rewood
Stokethestovefrequentlybutonlyaddsmallamountsoffuel
atatime.Ifthestove islled toofull, theheat createdmay
causeextremestressinthechimney.Add fuel to the re in
moderation.Avoidsmoulderingresasthisproducesthemost
pollution.Thereisbestwhenitisburningwellandthesmoke
fromthechimneyisalmostinvisible.
5.1 Danger of overheating
The replace must never be used in a
manner that causes overheating
Overheating occurs when there is too much fuel and/or too
much air so that too much heat develops. A sure sign of
overheating is when parts of the replace glow red. If this
happens,reducetheairventopeningimmediately.
Seek professional advice if you suspect that the chimney is
not drawing properly (too much/too little draught). For further
information,see«4.0 Installation» (Chimney and ue pipe).
5.2 Ash removal
• Only remove ash when the fireplace is cold.
• Use a scoop or similar to remove the ash through the door.
Always leave some ash as a protective layer on the bottom of
the fireplace.
5.2 Stacking wood
Min 100 mm
• Thewoodmustnotbestackedhigherthan100mmfrom
thebottomofthestove.

Related product manuals