Jøtul F 520 - Maintenance; Cleaning the Glass; Soot Removal; Chimney Sweeping

16
6.0 Maintenance
6.1 Cleaning the glass
The product is equipped with an air wash for the glass. Air is
sucked in through the air vent on the top of the product and
down along the inside of the glass.
However, some soot will always stick to the glass, but the
quantity will depend on the local draught conditions and
adjustmentoftheairvent.Mostofthesootlayerwillnormally
beburnedoffwhentheairventisopenedallthewayandare
isburningbrisklyinthereplace.
Good advice! For normal cleaning, moisten a paper towel
withwarmwaterandaddsomeashfromtheburnchamber.
Rub it over the glass and then clean the glass with clean water.
Drywell.Ifitisnecessarytocleantheglassmorethoroughly
werecommendusingaglasscleaner (follow the instructions
on the bottle).
6.2 Cleaning and soot removal
Soot deposits may build up on the internal surfaces of the
replaceduringuse.Sootisagoodinsulatorandwilltherefore
reducethereplace’sheatoutput.Ifsootdepositsaccumulate
whenusingtheproduct,theycaneasilyberemovedbyusing
asootremover.
Inordertopreventawaterandtarlayerfromforminginthe
replace,youshouldregularlyallowtheretoburnhotinorder
toremovethelayer.Anannualinternalcleaningisnecessary
togetthebestheatingeffectfromyourproduct.Itisagood
ideatodothiswhencleaningthechimneyanduepipes.
6.3 Sweeping ue pipes to the
chimney
Flue pipes must be swept through the ue pipe sweeping
hatch or through the door opening. The bafe and exhaust
deectormustberemovedrst.
6.4 Inspection of the replace
Jøtul recommends that you carefully inspect your replace
yourself after it has been swept/cleaned. Check all visible
surfaces for cracks. Also check that all joints are sealed
and that the gaskets are in the correct position. Any gaskets
showingsignsofwearordeformationmustbereplaced.
Thoroughly clean the gasket grooves, apply ceramic glue
(availablefromyourlocalJøtuldealer)andpressthegasket
well into place. The joint will dry quickly.
6.5 Exterior maintenance
Painted products may change colour after several years’
usage. The surface should be cleaned and brushed free of
any loose particles before new paint is applied.
Enamelled productsmustonlybecleanedwithaclean,dry
cloth.Donotusewaterandsoap.Anystainscanberemoved
withacleaninguid(oven cleaner etc.).
7.0 Servicing
Warning! Any unauthorised changes to the product are
illegal! Only original spare parts may be used!
7.1 Service/replacing parts in the burn
chamber
NB: Usetoolswithgreatcare!Thevermiculiteplatesmaybe
damagediftreatedroughly.
Fig. 14
1. First remove the log retainer
Fig. 15
A
B
2. First lift the baffle (A) up. Turn the key (B) 90° and then remove
the key. Pull the back edge of the baffle down.
ENGLISH