JPL Element X500 - Operating Instructions

Operating Instructions
Pairing a headset to the base unit:
1) Make sure there is no power to the base unit
2) Taketheheadsetothebaseunit
3) Hold the ‘mute button’ for 2-3 seconds until the blue indicator
lightontheheadsetstartstoash(IndicatingPairingMode)
4) Place the headset back on the base unit
5) Plug in the power cord to the base unit
6) Wait up to a minute and you should be able to hear an audible beep signifying the headset is
connected to the base unit
7) Testbytakingtheheadsetothebaseunit,whichshouldenabletheheadsettobe‘ohook’
(Greenphonelightactivated)andmakeatestcall.
Pairing a second headset to a base station:
1) Oneheadsetshouldalreadybepairedtothisbaseunit,ifsoitneedstobeturnedo
2) Toturntheheadseto,rstlytakeitothebaseunitandpressthecallaccept/rejectbuttonto
deactivate the green phone light on the base unit
3) Hold the call accept/reject button for 3 seconds, you should hear a short beep and then a longer
beepsignifyingtherstheadsetiso
4) Follow the steps in ‘Pairing a headset to a base unit’ above to connect the second headset
5) Oncethesecondheadsetisconnectedturntherstheadsetbackonwithashortpresstothecall
accept/reject button
6) Testtheheadsetsbycallingthephonesystemconnectedtothebaseunitandeachheadsetshouldring.
Please note: Pairing two headsets to one base unit allows each headset to answer the incoming call,
(amaximumofveheadsetscanbepairedtoonebaseunit)however,onlytheperson(therstto
answerthecall)willbeabletohearandinteractwiththecaller.
Mute
Please note: Your JPL-Element-X500 is supplied paired to the base unit straight out of the box.
However,ifaerchargingtheheadset,the‘GREEN’TELlightdoesn’tactivatewhentheheadsetis
removedfromthebaseunit,thenyoushouldfollowtheseinstructions.