Control Stick Length
G12
Advanced Digital Trims
The XP9303’s digital trims feature the Direct Access
display function. While at the Normal display screen, if a
trim lever is moved, the screen will automatically change
to display the graphic position for the trim being adjusted.
The XP9303’s Aileron, Elevator, Throttle and Rudder trim
levers feature an audible center trim beep. This is helpful
in determining the trim levers center position during
flight.
By using the Trim Step Function located in the System
Mode, the movement of the ADT trims can be fine tuned
as needed to match your specific application
Please also note that unlike conventional mechanical trim
levers, when the XP9303 transmitter is in the off position,
no changes can be made to the trim values during
transportation.
To adjust the stick length, use the 2mm Allen wrench
(supplied with your XP9303 transmitter) to unlock the
set screw. Turn the wrench counterclockwise to loosen
the screw. Then, turn the stick clockwise to shorten or
counterclockwise to lengthen. After the control stick
length has been adjusted to suit your flying style, tighten
the 2mm set screw. If you desire longer sticks, JR®
offers a stick (JRPA047) that is approximately one inch
longer than standard. This stick, crafted from bar stock
aluminum, is available at your local JR dealer.
LOOSEN
TIGHTEN
SET SCREW
To Next Page
Loading...
