XP9303 USED AS SLAVE (STUDENT) – (Trainer System)
A45
2. Highlight and select MASTER and the display will
switch to SLAVE. A message will appear instructing
to Connect DSC & POWER off. Make sure the TX
power switch is in the Off position and the DSC cord is
connected between the 2 transmitters.
The XP9303 is now ready to be used as the Slave or
student TX.
1. If the XP9303 is to be used as the Slave TX (TX used
by the student), be sure that the currently selected
model is set to PPM Modulation (see MODULAT in
the SYSTEM Menu if the Slave TX is a XP9303).
To Next Page
Loading...
