AIL DIFF. – AILERON DIFFERENTIAL (continued)
A32
2. At this point, it is assumed that there are to be 2
Aileron differential values. If one of these values is
set to zero, Aileron differential can be turned off by
selecting the position that has the 0 values. Highlight
and select Pos0 and set a small percentage of
differential or leave it set to zero (0) if the ability to turn
differential off is desired. Highlight and select Pos1
and set the percentage of differential. A positive value
causes the downward Aileron to travel less, while a
negative value causes the upward Aileron to travel less
(negative differential). The example below shows a
positive percentage in Pos0 for precision flying and
a negative differential for Pos1 for flat spins, which is
selectable with Flight Mode 2 (FM2).
3. Scroll down to the bottom line of the display to select
the Flight Mode and/or switch(es) that is to be used
to switch between the Aileron Differential settings. The
throttle may also be used to switch between differential
settings by highlighting and selecting THRO STK and
setting the percentage of throttle to the point where
the values are switched. Test fly the aircraft and return
to this function to make adjustments until the yaw
tendency has been eliminated.
Note: Pos1 always has priority over Pos0. In
other words, if multiple switches are selected and
one of the switches is in its Pos1 position, then
all other switches are ignored and the Pos1 values
are in effect.
To Next Page
Loading...
Need help?
General
