COPY – COPY CURRENT MODEL (continued)
A49
3. Verify that the top model is the model that is to be
backed-up and the lower model is empty or contains
a model that is no longer required. When satisfied that
all is well, press the CLR button on the left side of
the display next to COPY. The entire contents of the
currently selected model is copied to the lower model
on the display and there is now a complete backup of
the current model. The upper and lower model memory
names are now the same because the two model
memories are now identical in every regard.
The backup copy can now be used to restore the
original at any time by performing the Copy function and
reversing the order of models where the backup is copied
into the original (Backup copy on the top line and the
original model memory on the bottom line).
The display shows the currently selected model on top
with a down-arrow pointing to the lower model memory
that the current model will be copied into. The data that
is presently in the lower model memory will be entirely
replaced by the data in the currently selected model, so
be sure that the lower model memory is either empty or
contains data that is no longer required.
To change the lower model memory that is to
receive the copy of the current model, highlight and
select the lower model name and number. Then scroll to
an unused model memory or a memory that contains data
that is no longer required, and select it.
To Next Page
Loading...
Need help?
General
