RECEIVE A MODEL INTO THE XP9303 – (Transfer function)
A51
1. Hold the ENT button while plugging the DSC cord
into the back of the transmitter to obtain the SYSTEM
Menu. Plug the other end of the DSC cord into
another XP9303 transmitter while holding the ENT
button and prepare that transmitter for Transmit as
described above. Or, plug the other end of the DSC
cord into a DataSafe unit and prepare the DataSafe for
Transmit.
2. Highlight and select TRANSFER in the SYSTEM
Menu to obtain the Transfer display.
3. If RECEIVE is already displayed, continue with the
next step. If TRANSMIT is displayed, highlight and
select TRANSMIT, changing it to RECEIVE.
4. Select the model memory that is to receive the data by
highlighting and selecting the model name/memory
number and then scrolling to and selecting the model
memory that is to receive the data. Be careful to select
an unused model memory or a memory that contains
data for a model that is no longer needed because the
data in this model memory is going to be replaced by
what is transmitted and will be permanently lost.
5. Press the CLR button next to START on the left side
of the display. Stand-by appears at the bottom of
the display indicating that the XP9303 is ready to
receive data. Press start on the transmitting XP9303 or
DataSafe unit to begin the data transfer to the XP9303.
To Next Page
Loading...
Need help?
General
