ġ
4-18
4
[II] Sector Blank Area Creation (Make Sectors 1, 2, and 3)
Procedures 1. Transmit the radar.
2. Open the Adjust Menu.
3. Press [4] key.
Press [6] key.
The Sector Blank Menu will appear.
4. Select the number you want to make
sector blank, pressing the numeric keys
[4] to [6].
The sector blank for the numeric key pressed will be
made.
5. Set the start point of the sector blank by
operating the [EBL] dial, and then press
ENT.
The start angle of the sector blank will be set.
6. Set the end point of the sector blank by operating the [EBL] dial, and
then press ENT.
The end angle of the sector blank will be set.
To Next Page
Loading...
Need help?
General
