4-37
4.18 DGPS RECEIVER SETTING
Set to a JRC’s DGPS receiver.
This setting is enabled when a JRC’s DGPS is connected to the GPS connector of processor unit.
[I] Beacon frequency mode setting (Mode)
Procedures 1. Press [RADA MENU] key.
The Main Menu will appear.
2. Press [7] key.
The NAV Equipment Setting screen will appear.
3. Press [7] key.
The GPS Setting screen will appear.
4. Press [2] key.
The GPS Setting screen will appear.
5. Press [1] key.
Pressing [1] key will toggle between AUTO and
Manual.
6. After the entry has been completed, press [5] key to send the settings to
the DGPS receiver.
To Next Page
Loading...
Need help?
General
