3-43
3.16 CONNECTING TO AIS (NQA-2155)
(OPTION)
1) Connection
1.1) Connecting the AIS processing circuit
If AIS process circuit is not installed in the radar process unit, install it according to the procedures
below:
(1) Set the jumper plugs and the switches, as shown in the figure.
(At installation in the processor, the jumper is installed at the bottom.)
(2) Remove the processor unit cabinet cover.
(3) Set the jumper of the power supply unit.
Set TB3J 2-TB3J3 (DIRECT).
To Next Page
Loading...
Need help?
General
