4
3. Set a port for each sensor.
Settable sensor signals
GPS, DLOG, Alarm, Depth, Temperature, Wind, Current, ROT, RSA
Selectable ports
When the automatic recognition function is used: AUTO
When ports are specified: NAV1, NAV2, GPS, and NMEA
[III] Reception Sentence Setting (RX Sentence)
Set signal sentences to be received from sensors.
The system is factory-set for using all sentences.
To receive only specified sentences, select No Use for sentences which are not necessary.
Procedures 1. Open the Serviceman Menu.
2. Perform the following menu open procedure to open the RX Sentence
setting menu.
2. Installation Menu
→ 5. COM Port Setting
→ 3. RX Sentence
3. Select the sentences to be used by the sensors to be set.
Selection value: (Use) or (No Use) can be set for each sentence.
1. GPS(LL/COG/SOG) : GGA/RMC/RMA/GNS/GLL/VTG
2. GPS(WPT/Time) : GGA/RMC/RMB/BWC/BWR/ZDA
3. Depth : DPT/DBK/DBT/DBS
4. Wind : MWV/MWD
5. Current
Data Set Number : 0-9. Set the number of the sentence to be used by Data Set
Number. (Initial value All)
Layer A : 0-
999. Set the number of the sentence to be used with layer A
by Layer Number. (Initial value 3)
Layer B : 0-
999. Set the number of the sentence to be used with layer B
by Layer Number. (Initial value 4)
Layer C : 0-
999. Set the number of the sentence to be used with layer C
by Layer Number. (Initial value 5)
6. Autopilot : APB (default value : Not Use)
4-10
To Next Page
Loading...
Need help?
General
