JRC JMR-9210-6X - Starting and Preparing the ECDIS; Powering on and Starting

8-3 Section 8 Functions of the ECDIS (Option)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
8.2 Starting and Preparing the ECDIS
8.2.1 Powering on and starting
The ECDIS is powered on according to the following procedure.
Do not leave a disk in the DVD drive.
This may result in a drive problem.
In the case of turning on the power under the condition of low temperature,
do pre-heat more than 30 minutes.
The equipment may not be operated normally.
And accidents may
result.
1 Press the Power ON button on the operation unit.
The Power button illuminates. After a while, the Task menu is displayed.