Section 9 Route Planning 9-20
Note
When editing the file of the route being monitored, if the limit check detects a turning radius
error ("The straight route can not be created."), The following popup will be displayed when
saving.
To cancel the save operation, close the dialog box by clicking on the [OK] button or the [X]
button. When saving the file by changing the file name, click on the [Save as...] button. The
dialog box is closed and the [Save as Route File] dialog box appears.
Saving a route file by naming the file
Click on [Save as...] of the route planning menu button on the Route Planning bar.
When the [Save as Route File] dialog box appears, save the file by entering a new file name.
Setting a route file to a Read Only mode (disabling editing)
Check Read only for the file that is to be set to [Read only] (disabling editing) mode. To cancel Read
Only (disabling editing) specification, clear the check.
To Next Page
Loading...
