To Next Page

To Previous Page

3.3 MOUNTING THE DISPLAY UNIT

When planning the installation for your display unit, the following conditions

should be considered to ensure dependable and trouble free operation.

1) The mounting location should be easily accessible to allow operation of the

front panel controls.

2) There should be adequate ventilation.

3) There should be sufficient space behind the display unit to allow cable con-

nections to the rear panel connectors.

4) The display unit should be located near a DC power source.

5) The selected location should be far enough away from device that may cause

interference, such as motors and generators.

6) Generally, the display unit should be located in a protected area away from

prolonged direct exposure to rain and salt spray. It is good practice to pro-

tect your valuable electronic equipment as much as possible.

The display unit can be conveniently mounted on a chart table, or bulkhead

mounted in a desired location. Using the outline of FIG 3-1 and 3-2 as a guide,

install the display unit and secure to the mounting surface.

INSTALLATION