To Next Page

To Previous Page

5.14 Built-in recording

1) Insert USB drive on the back panel

2) The recording pilot light on the panel showing cross-

ashing between red light and green light repre-

sents USB drive is under the status of preparation.

3) The recording pilot light will show green light when

USB preparation is completed and press recording

button to start recording.

4) When press the recording button and the recording

pilot light shows red light, it enters recording mode.

5) To end recording, press and hold the recording but-

ton and wait the light signal showing cross-ashing

between red light and green light before releas-

ing the releasing button and the recording will be

terminated.

PS: When the red light ashes slowly during the

recording process, it represents the USB capacity is

lower than 20MB to remind the user to replace USB

drive. When the red light turns into rapid ashing,

it represents the USB capacity is lower than 10MB,

and the recording will be terminated at any time. If

the recording pilot light is not on, it represents USB

is not inserted or unable to be detected.

*CS-1CUR

Recording button

Recording pilot light

JTS CS Series User Manual

Questions and Answers: