LT-591 (September, 2003) 1/1
LT-591
SPECIFICATIONS
KINDS OF HIGH WOODEN BUCK TABLE
Model name
Max. sewing speed
Stitch length
Feed mechanism
Needle bar stroke
Max. lift of the presser
Needle (at the time of delivery)
Hook
Operation system
Lubrication
Lubricating oil
Bed size
Weight of the machine head
LT-591
600rpm
Free
Without feed mechanism (manual)
52.8mm
By hand: 35mm
TV×7 (#14)
Vertical-axis large hook
(dia. of bobbin: 37mm, amount of bobbin tread is over 5 times more than previous models)
Automatic stop system by pedal action
By an oiler
JUKI New Defrix Oil No.1 (equivalent to ISO VG7)
440mm×178mm
53kg
● In order to overcome the weakness of rapid consumption of the bobbin
thread, the amount of wound bobbin thread is increased to over 5 times
that of previous models. Thus, the bobbin thread changing time is
more shortened than the previous models and naturally the production
efficiency is greatly upped.
● As either a flat-bed type or a high wooden buck type auxiliary table can
be used, the usage is very wide.
● When the treadle is stepped on, the machine starts and when the foot
is released, the machine always stops at a required position.
Therefore, the machine can be stopped at each stitch and thus, this is
an ideal machine for basting of complicated process which demands
accurate basting.
LT-591
Post-bed, 1-needle, Lockstitch, Basting Machine
A
B
C
D
Usage-example
A: Round A type
Basting front interlining
B: Round B type
Basting front
Basting neckline
Basting front facing
Basting bottom
C: Flat A type
Basting pad
D: Flat B type
Basting sleeve cuff
Basting sleeve lining, etc.
To Next Page
Loading...
Need help?
General
