1-9-2. Checking the Cable Marking (X)
(1) Check the marking position of the XY veyor-cable (40058385).
(Place the marks at a position 350mm from the CN805 connector end.)
For the machine with the extra specifications, the following cables are used.
XY veyor-cable (E) 40059779
Y veyor-cable (E) 40059789
This instruction also applies to the following pages.
Figure 1-9-2-1
(2) Check the marking positions of the 1394 robot cable (40044517) and the optical fiber cable
7M (40044543).
(At this time, place a mark at a position 1150mm from the connector end of the 1394 robot
cable and at a position 290mm from the connector end of the fiber cable.)
1394 robot cable
For the machine with the extra
specifications, the following cable is used.
1394 robot cable (E) 40080215
This instruction also applies to the
following pages.
1150
OPTICAL FIBER CABLE 7M
To Next Page
Loading...
