JUKI KE-2080 - Page 79

Maintenance Guide
2-19
 After cutting the tie-up band(s) to remove the FMLA, bundle cables as shown below.
Figure 2-5-4
40080206
LA SENSOR BEAR CABLE ASM
 Insert the cable assembly firmly.
EA9500B0100
Tie-up band (small)
x Connector on far side of
left sensor
EA9500B0100
Tie-up band (small)
x Connector on front side
of right sensor
EA9500B0200
Tie-up band (medium)
E93457210A0
LA SENSOR CONNECT
CABLE ASM
 Insert the cable
assembly firmly.
Note: Fix the connector
cable at a position
where it is not in
contact with the
release bar.
x Connector on front side
of left sensor