Operation manualⅠContents
For the safe operation of machinery
Table of contents
Introduction....................................................................................................
Overview of This Manual
Notational Conventions
Organization of This Manual
Glossary
Chapter 1 Overview of the Machine ........................................................... 1-1
1.1. Overview of this machine............................................................. 1-1
1.2 Configuration of the machine ....................................................... 1-2
Chapter 2 Operation Procedure.................................................................. 2-1
2.1 Flow of PWB production............................................................... 2-1
2.2 Overview of operations................................................................. 2-2
Chapter 3 Various Processes During PWB Production ........................... 3-1
3.1 When components run out (If the check box "Stop system when
components run out" is checked on the "Operation option"
screen) ....................................................................................... 3-1
3.2 When components run out (If the check box "Stop system when
components run out" is not checked on the "Operation option"
screen) ......................................................................................... 3-2
3.3 When a mark recognition error occurs ......................................... 3-3
3.4 When the laser sensor is stained................................................. 3-4
3.5 When an error (LA recognition error, tombstone error or
irregularly-shaped component error) occurs ................................ 3-5
3.6 When a vision recognition error occurs........................................ 3-6
3.7 When a nozzle error occurs ......................................................... 3-7
3.8 When a feeder float error is detected........................................... 3-8
3.9 When a cover open error occurs.................................................. 3-9
3.10 When the feeder bank moves down (only if an overall feeder
exchange trolley option is attached on the machine)................... 3-10
3.11 Pause for protection of a component ........................................... 3-11
3.12 Continuous PWB production ........................................................ 3-12
To Next Page
Loading...
