Operation manualⅠ
S-1
Introduction
Overview of This Manual
This is an introduction to PWB production with a KE-2070/2070C, 2080/2080R mounter.
When you read and understand this manual thoroughly, you can use a created
production program to produce PWBs.
Refer to the attached “Operation Manual II (for Programmers and Administrators)” for
how to create a production program or other settings.
Note that the detailed information on PWB production is stored on the attached CD
“KE-2070/2080/2080R Instruction Manual.”
Notational Conventions
• A menu name is enclosed with double-quotation marks and a command name is
enclosed with square brackets ([ and ]).
When you have to select two commands sequentially, “/” is used between these two
consecutive commands.
Example: [File]/[Open]
• A proper name is enclosed with double-quotation marks.
• A key is enclosed with angled brackets (< and >).
Example: <ESC> and <ENTER>
• A manual name is enclosed with double-quotation marks.
Example: “KE-2080 Instruction Manual”
• When two or more names that are related with each other are described, “/” may be
used instead of “and.”
Example: KE-2070 and KE-2080 → KE-2070/2080
Windows 2000 and Windows XP → Windows 2000/XP
Organization of This Manual
• Chapter 1 Overview of the Machine
This chapter describes the configuration and overview of the machine.
• Chapter 2 Operation Procedure
This chapter describes the flow of operations from power-on to PWB production.
• Chapter 3 Daily Inspection
This chapter describes the daily inspection together with the lists of daily inspection
items and maintenance items.
This manual is an introduction to PWB production with a KE-2070/2070C,
KE-2080/2080R mounter. Refer to the descriptions stored in the attached CD
“KE-2070/KE-2080/KE-2080R Instruction Manual” for operations not described in this
manual.
To Next Page
Loading...
