－
97
－
Shorter remaining thread
suction pipe (coming from
the throat plate base)
Bird's nest suction pipe
(coming from the bed)
2) Connect shorter remaining thread suction pipe
and suction tube asm.
.
Fix suction tube asm.
on the bed (at two locations) with cord clamp (small)
.
3) Fix shorter remaining thread suction pipe
at the cylinder section (one location) of bed with cord clamp
(medium)
.
At this time, carefully prevent shorter remaining thread suction pipe
from coming in contact
with the moving section (including the cylinder rod). In addition, operate the sewing machine to
check whether shorter remaining thread suction pipe
moves smoothly without a hitch. If the
pipe fails to move smoothly, re-check how it is xed.
4) Connect bird's nest suction pipe
and suction tube asm.
.
Secure two suction tube asms.
, and four air tubes and two sensor cords coming from the sewing
machine head together on the bed with cord clamp (large)
.
5) Bundle bird's nest suction pipe
and two air tubes and one sensor cord coming from the sewing ma-
chine head together with cable clip
.
6) Secure the air tube and cylinder sensor cords
with cable clip
.
Fix the air tube and cords so that they
are neither crushed nor applied with un-
necessary force when tilting the machine
head.
To Next Page
Loading...
