14
Check that the place between lower line
B
and upper
line
A
is lled with oil. Fill there with oil using the oiler
supplied with the machine as accessories when oil is
short.
* The oil tank which is lled with oil is only for lubri-
cating to the hook portion. It is possible to reduce
the oil amount when the number of rotation used
is low and the oil amount in the hook portion is
excessive. (Refer to
"I.7-8. Amount of oil sup-
plied to the hook" p.53
.)
1. Do not lubricate to the places other
than the oil tank and the hook of Cau-
tion 2 below. Trouble of components
will be caused.
2. When using the sewing machine for
the rst time or after an extended pe-
riod of disuse, use the machine after
lubricating a small amount of oil to the
hook portion. (Refer to "I.7-2. Adjusting
the needle-to-shuttle relation" p.50.)
Loosen setscrew
and hold needle
with the long
groove
facing toward you. Then fully insert it into
the hole in the needle bar, and tighten setscrew
.
If the stitches are made as shown in
,
attach the needle facing to the direction
to a small extent.
4. OPERATION OF THE SEWING MACHINE
4-1. Lubrication
4-2. Attaching the needle
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
A
B
To Next Page
Loading...
