32
6-2. Sewing using the combination function (cycle sewing)
This sewing machine can perform sewing of plural sewing pattern data in one cycle in the order of the data.
As many as 99 patterns can be input. Use this function for sewing two or more different patterns on the sewing
product. In addition, registration of as many as 99 cycles can be performed. Copy and use the data to ll the
needs.
→
Refer to
"I.6-6. Copying or deleting various kinds of pattern data" p.40
(1) Selection of cycle data
1) Set the mode to the input mode.
Under the input mode where SET READY LED
goes out, selection of the cycle data is en-
abled.
If the current mode is the sewing mode, press
READY key
to change over the mode
to the input mode.
Only under the input mode, selection of the cycle
data is enabled.
2) Select cycle stitching data.
Press ITEM SELECT key
, and pat-
terns which have been registered are changed
over and displayed in order. Cycle data No. and
continuous stitching data No. which have been
registered after the last registered pattern No. are
displayed. Here, select the cycle data No. which
you desire to sew.
3) Perform sewing.
When READY key
is pressed in the
state where the cycle data is selected, SET
READY LED
lights up to show that the sewing
is enabled.
Cycle data No. 1 only has been registered at the
time of your purchase. However, sewing status
cannot be obtained since the sewing pattern has
not been inputted. Perform inputting of sewing
pattern referring to
(2) Method of editing cycle
data
on the next page.
To Next Page
Loading...
