－
96
－
2-2. Installing the regulator and solenoid valve asm.
Mount the solenoid valve asm. and regulator asm. on the undersurface of the table respectively with two set-
screws
and two setscrews
.
Mount the solenoid valve asm., near cord through-hole
(see the gure) in and regulator asm. on the far left
section of the undersurface of the table as observed from the worker.
2-3. Connecting the air piping
(1) Connecting the suction pipe
1) Pass the suction tube and air tube
through hole
in the table from
undersurface.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
To Next Page
Loading...
