8
Remove tape
xing the lever section of safety switch
.
In case error 302 occurs when the sewing machine works after setup, loosen the safety switch
tting screw with a screwdriver, and lower the switch to the downside of the sewing machine.
3-9. Safety switch
1) Fix drain receiver
in the installing hole of table
with two setscrews
.
2) Screw poly-oiler
in waste oil reservoir
.
3) Insert sewing-machine waste oil pipe
into po-
ly-oiler
.
4) Insert head support rubber
into table
.
5) Pass bundle
of cords through slotted hole
in the table.
1.
Insert drain pipe
until it will go no fur-
ther so that it does not come off drain
bin
when tilting the machine head.
2. Remove the tape xing drain pipe
.
3-8. Installing the drain receiver and the head support rubber
DANGER:
When using the safety switch without removing tape
, it is very dangerous since the sewing ma-
chine works even in the state that it is tilted.
To Next Page
Loading...
