JUKI SC-810 - Page 18

– 12 –
5) Press / switch
2
to make number of
stitches display
8
ash on and off, and set the
number of stitches for the respective processes
of the stitching.
6) Press
switch
4
or switch
3
to change
the number of stitches.
The number of stitches can be changed up to as
many as 15 stitches for the A, B, C, and D proc-
esses respectively.
However, displays are as follows.
10 stitches = A, 11 stitches = b, 12 stitches = c, 13
stitches = d, 14 stitches = E and 15 stitches = F
7) When the setting of all items has been completed,
press
/ switch
1
to determine the con-
tents of the setting. (Flashing stops.)
(2) Overlapped stitching pattern
2
1
3
4
8
Flash
Overlapped stitching pattern
Reverse stitching pattern
⇔
2
1
2
1
LED lights Up. LED lights Up.
Flash
2
1
3
4
Overlapped stitching patterns below can be set by using the operation panel.
A : Number of stitches of normal stitching setting
0 to 15 (F) stitches
B : Number of stitches of reverse stitching setting
0 to 15 (F) stitches
C : Number of stitches of normal stitching setting
0 to 15 (F) stitches
D : Number of times of repetition
0 to 9 times
(Caution) When process D is set to 5 times, the sew-
ing is repeated as A
/
B
/
C
/
B
/
C.
[Setting procedure of the overlapped stitching]
1) Hold pressing
/ switch
2
, and press
/ switch
1
to select the overlapped stitching
pattern.
(Every time / switch
1
is pressed, re-
verse stitching pattern/overlapped stitching pat
-
tern change over alternately.)
2) The number of stitches for process A becomes in
ashing state.
3) Every time
/ switch
2
is pressed, the
ashing position shifts in the right direction and
the display of the process where setting can be
changed ashes on and off.
4) Press
switch
4
or
switch
3
to change
the number of stitches.
5) When the setting of all processes has been com
-
pleted, press
/ switch
1
to determine
the contents of the setting. (Flashing stops.)
(Caution) When the overlapped stitching is selected,
the automatic operation display flashes
on and off. It is not possible to release the
automatic operation.
A
B
C
B
C
D