Julabo F32-HE - 5.2. Bath fluids

Preparations
28
5.2. Bath fluids
Caution:
Carefully read the safety data sheet of the bath fluid used, particularly with regard to
the fire point!
If a bath fluid with a fire point of d65 °C is used, only supervised operation is possible.
Water: The quality of water depends on local conditions.
x Due to the high concentration of lime, hard water is not suitable for temperature
control because it leads to calcification in the bath.
x Ferrous water can cause corrosion - even on stainless steel.
x Chloric water can cause pitting corrosion.
x Distilled and deionized water is unsuitable. Their special properties cause
corrosion in the bath, even in stainless steel.
Recommended bath fluids:
Bath fluid Temperature range
soft/decalcified water 5 °C to 80 °C
mixture water/glycol, mixture 1:1
-20°C to 50°C
JULABO bath fluids
JULABO
Description
Thermal
G
Thermal
HY
Thermal
H5
Order Number 10 liters 8 940 124 8 940 104 8 940 106
5 liters 8 940 125 8 940 105 8 940 107
Temperature range °C -30 ... 80 -80 ... 55 -50 ...105
Flash point °C -- 78 124
Fire point °C -- 80 142
Color light yellow clear clear
JULABO
Description
Thermal
H10
Thermal
H20S
Order Number 10 liters 8 940 114 8 940 108
5 liters 8 940 115 8 940 109
Temperature range °C -20 ... 180 0 ... 220
Flash point °C 190 230
Fire point °C 216 274
Color clear light brown
See website for list of recommended bath fluids.
ATTENTION: The maximum permissible viscosity is 70 mm
2
/s
.
www.calcert.com sales@calcert.com1.888.610.7664
0
5
10
15
20
25
30